Class Presentations

We spent a little time preparing power point presentations on current products and then they presented them to the class. I have about 4 hours of video but I will just share a few pictures.

Service Advisor Certification

Back in November the sophomores came back from OJT for their final 5 months of school. With 76 John Deere Tech students on campus our parking lot gets a little full but we found room for everyone.

Neil and Rodney helped the freshmen who were busy lubricating the floor and the door knobs with oil in Hydraulics 1. Matt and Duane helped the sophomores who were getting their fill of computers and live connections. The sophomores tested for John Deere Service ADVISOR certification with a 100% of them passing. We also had presentations on biodiesel and JD Link and the sophomores also had opportunities to do a little presenting on their own.

We were busy but we did have time to grill 50 lbs. of brats and we had multiple opportunities for some Kwik Star donuts.

Here is a picture from the biodiesel presentation.

Current Draw and Heat

Here are a couple videos that demonstrates the comparison of amp draw and increased resistance caused by heat. Allow both videos to load and and click play on both at the same time to see the comparison. Note: Click the bottom video first.

 

 

Electric I Class Wraps Up

We are just finishing Electric I Class. We have been working on voltage drops, Ohm's law, battery testing, JICs and numerous other emotional experiences. Here are some pics.

 

Electrical Sites

Here are some electrical sites to play with.

http://phet.colorado.edu/en/simulation/circuit-construction-kit-dc

http://www.autoshop101.com/

The First Class Is Over

It doesn't seem possible but Fundamentals and Safety class finished on Tuesday. We have successfully turned a 9600 and a 7720 into a pile of parts. We have discovered that you can use these precision "C" clamps in our toolboxes to actually measure things very accurately and averaged 90% on the final micrometer test. We can look at cap screws and identify their size by sight. We can recognize many TLA (Three Letter Acronyms) and we even know how to turn on Service ADVISOR. Thirty nine students come back every day! Sounds like success to me!
 Now it’s time to start Implement class.

Fundamentals and Safety Class

We are nearing the end of the first class and we have been busy learning about fasteners, fire extinguishers, micrometers and torque wrenches. We have been driving new tractors and moving wheels. We also have successfully turned two combines into a large pile of parts.

 

This is the 7.6L engine from the 9600 combine. We needed to make sure it ran and had oil pressure for Tri-State. We used a harness for an 8.1L engine that we made during last years engine class just to make it run and all we got was uncontrolled RPM. Rodney is regulating the speed by limiting the air. A lot of fuel and limited air equals a lot of smoke.

 

Welcome To A New Instructor

We would like to welcome Matt Johnson as a new instructor to the John Deere Tech program. He graduated from the John Deere Tech program in 2000 and has been working as a technician at Decorah Implement since 1998. He has worked with several students at the dealership and has achieved the John Deere Master Technician Certification. We welcome his current product knowledge and enthusiasm. If you get a chance stop in and welcome him to the team.

Let The Fun Begin

We finally got to lab and started taking apart the combines. We are also working with the new tractors and learning about safety. Service ADVISOR is becoming our new best friend!

The Combines Have Arrived

We unloaded the combines for disassembly on Friday. Now if we get them cleaned up a little we can start tearing them down. It shouldn't take too long with 40 students working on them. We will also be working on wheel moves and and predelivery of new tractors.